Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the evaporative emission canister purge solenoid valve (2) to the bracket (1).

Fig 1: Evaporative Emission Canister Purge Solenoid Valve
Courtesy of GENERAL MOTORS COMPANY
Remove the cap from the fuel tank vent pipe.
Connect the wiring harness plug (3) to the evaporative emission canister purge solenoid valve (2).

Fig 2: Evaporative Emission Pipe And Evaporative Emission Canister Purge Solenoid Valve
Courtesy of GENERAL MOTORS COMPANY
Install the evaporative emission pipe (1) to the evaporative emission canister purge solenoid valve (2).
Remove the cap from the evaporative emission pipe.
Install the fuel tank vent pipe (2) to the evaporative emission canister purge solenoid valve (1) and to the clip (3).

Fig 3: Fuel Tank Vent Pipe And Evaporative Emission Canister Purge Solenoid Valve
Courtesy of GENERAL MOTORS COMPANY
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
Close the hood.