LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the spark plugs. Refer to Spark Plug Replacement .
  2. Remove the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .
  3. Remove both camshafts. Refer to Camshaft Replacement .
  4. Remove the valve lifter. Refer to Valve Lifter Replacement .
  5. For cylinder 1 and 4 set the crankshaft to TDC marking, cylinder number 1. Use the crankshaft balancer bolt.
    Fig 1: Aligning Timing Belt Drive Gear And Oil Pump Housing
    GM2027014Courtesy of GENERAL MOTORS COMPANY
  6. For cylinder 2 and 3, set the crankshaft BDC (180 degrees from TDC marking). Use the crankshaft balancer bolt.
  7. Shift to 1st gear (MT) or park position (AT) and apply the park brake.
    NOTE: Wheels must contact the ground.
scientia non olet · About LEMON Manuals