LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the crankshaft in direction of engine rotation to 60 degrees (a) before TDC. Use the EN-45059  meter and the crankshaft balancer bolt.
    Fig 1: Turning Crankshaft Against Direction Of Engine Rotation
    GM2027016Courtesy of GENERAL MOTORS COMPANY
  2. Install the valve lifter. Refer to Valve Lifter Replacement .
  3. Install both camshafts. Refer to Camshaft Replacement .
  4. Install the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .
  5. Install the spark plugs. Refer to Spark Plug Replacement .
scientia non olet · About LEMON Manuals