LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - On Vehicle >> Timing Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the timing belt idler pulley (1) and tighten the NEW bolt (2) in three passes use the EN-45059  meter:
    Fig 1: Timing Belt Idler Pulley Bolt
    GM2026843Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    CAUTION: Refer to Torque-to-Yield Fastener Caution .
    1. First pass tighten to 20 N.m (15 lb ft).
    2. Second pass to 120 degrees.
    3. Final pass to 15 degrees.
  2. Install the timing belt. Refer to Timing Belt Replacement .
scientia non olet · About LEMON Manuals