LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (Automatic Transmission) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  3. Remove the drive belt. Refer to Drive Belt Replacement .
  4. Remove the bolt (1).
    Fig 1: Automatic Transmission Bracket Bolt
    GM2538037Courtesy of GENERAL MOTORS COMPANY
  5. Install the EN-6625  locking device (2) to lock the crankshaft.
    Fig 2: Locking Device And Bolt
    GM2027000Courtesy of GENERAL MOTORS COMPANY
  6. Install the bolt (1).
  7. Remove and DISCARD the crankshaft balancer bolt (1).
    Fig 3: Crankshaft Balancer And Bolt
    GM2027569Courtesy of GENERAL MOTORS COMPANY
  8. Remove the crankshaft balancer (2).
scientia non olet · About LEMON Manuals