LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement (Automatic Transmission) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the crankshaft balancer (2).
    Fig 1: Crankshaft Balancer And Bolt
    GM2027569Courtesy of GENERAL MOTORS COMPANY
  2. Install a NEW crankshaft balancer bolt (1) and tighten a first pass to 95 N.m (70 lb ft).
    CAUTION: Refer to Fastener Caution .
    CAUTION: Refer to Torque-to-Yield Fastener Caution .
  3. Tighten the NEW crankshaft balancer bolt a second pass to an additional 45 degrees, using the EN-45059  meter.
  4. Tighten the NEW crankshaft balancer bolt a final pass to an additional 15 degrees, using the EN-45059  meter.
  5. Remove the bolt (1).
    Fig 2: Locking Device And Bolt
    GM2027000Courtesy of GENERAL MOTORS COMPANY
  6. Remove EN-6625  locking device (2) to unlock the crankshaft.
  7. Install the bolt (1) and tighten to 45 N.m (33 lb ft).
    Fig 3: Automatic Transmission Bracket Bolt
    GM2538037Courtesy of GENERAL MOTORS COMPANY
  8. Install the drive belt. Refer to Drive Belt Replacement .
  9. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals