Water Pump Pulley Installation

WARNING: This page is about a different variant/trim than selected.

Install the water pump pulley (2) to the water pump (3).

Fig 1: Water Pump And Water Pump Pulley
Courtesy of GENERAL MOTORS COMPANY

NOTE: Counterhold the crankshaft balancer. The belt has to be installed for this procedure.
Install the 3 water pump pulley bolts (1) with locking compound and tighten to 20 N.m (15 lb ft).
CAUTION: Refer to Fastener Caution .

Refer to Adhesives, Fluids, Lubricants and Sealers .