LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - Off Vehicle >> Oil Pan Installation

Oil Pan Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the sealing surfaces.
    Fig 1: View Of Joints For Sealant
    GM1944491Courtesy of GENERAL MOTORS COMPANY
  2. Apply approximately a 3.5 mm (0.138 in) thick bead of oil pan sealant to the joints (arrows). Refer to Adhesives, Fluids, Lubricants and Sealers  for the recommended sealant.
  3. Apply approximately a 3.5 mm (0.138 in) thick bead of oil pan sealant (1) to the oil pan. Refer to Adhesives, Fluids, Lubricants and Sealers  for the recommended sealant.
    Fig 2: Sealant Application Area
    GM2189266Courtesy of GENERAL MOTORS COMPANY
    NOTE: The assembly time, including torque check, must take no longer than 10 minutes.
  4. Install the oil pan (2).
    Fig 3: Oil Pan And Bolts
    GM2027008Courtesy of GENERAL MOTORS COMPANY
  5. Install the 15 oil pan bolts (1) on the cylinder block and tighten to 10 N.m (89 lb in).
    CAUTION: Refer to Fastener Caution
scientia non olet · About LEMON Manuals