LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - Off Vehicle >> Engine Oil Cooler Housing Installation

Engine Oil Cooler Housing Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the engine oil cooler housing to thermostat housing sealing surfaces.
  2. Install 2 NEW gaskets.
  3. Install the engine oil cooler inlet pipe (3).
    Fig 1: Identifying Engine Oil Cooler Housing, Bolts And Engine Oil Cooler Inlet Pipe
    GM2026867Courtesy of GENERAL MOTORS COMPANY
  4. Install the engine oil cooler housing (1) and the 5 engine oil cooler bolts (2) and tighten to 25 N.m (18 lb ft).
  5. Install the thermostat housing coolant pipe (2) to the engine oil cooler housing.
    Fig 2: Identifying Engine Oil Cooler Outlet Pipe And Bolts
    GM2026830Courtesy of GENERAL MOTORS COMPANY
  6. Install the 2 thermostat housing coolant pipe bolts (1) and tighten to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals