LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - Off Vehicle >> Cylinder Head Removal

Cylinder Head Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the 10 cylinder head bolts in sequence as shown.
    Fig 1: Cylinder Head Bolts Tightening Sequence
    GM2027932Courtesy of GENERAL MOTORS COMPANY
    1. Loosen the 10 bolts 90°.
    2. Loosen the 10 bolts 180°.
  2. Remove the cylinder head and place on a suitable base.
  3. Remove the cylinder head gasket.
scientia non olet · About LEMON Manuals