LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Repair Instructions - Off Vehicle >> Camshaft Removal

Camshaft Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the 4 camshaft bearing cap bolts.
    Fig 1: Camshaft Bearing Cap And Camshaft Bearing Cap Bolts Removal Sequence
    GM2026542Courtesy of GENERAL MOTORS COMPANY
    NOTE: Note removal sequence 1-4.
  2. Remove the first camshaft bearing cap (1).
    NOTE: Release the bearing support by striking it gently with a plastic hammer.
  3. Loosen the 8 exhaust camshaft bearing cap bolts working from outside to inside in a spiral in steps of 1/2 up to 1 turn.
    Fig 2: Exhaust Camshaft Bearing Cap Bolts Loosening Sequence
    GM2027653Courtesy of GENERAL MOTORS COMPANY
  4. Remove the 8 exhaust camshaft bearing cap bolts.
  5. Remove the 4 exhaust camshaft bearing caps numbers 6-9 from the cylinder head.
    NOTE: Mark camshaft bearing caps before removal.
  6. Remove the exhaust camshaft (1).
  7. Loosen the 8 intake camshaft bearing cap bolts working from outside to inside in a spiral in steps of 1/2 up to 1 turn.
    Fig 3: Intake Camshaft Bearing Cap Bolts Loosening Sequence
    GM2027651Courtesy of GENERAL MOTORS COMPANY
  8. Remove the 8 intake camshaft bearing cap bolts.
  9. Remove the 4 intake camshaft bearing caps numbers 2-5 from the cylinder head.
    NOTE: Mark camshaft bearing caps before removal.
  10. Remove the intake camshaft (1).
  11. Remove the camshaft seal rings.
scientia non olet · About LEMON Manuals