LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Diagnostic Information and Procedures >> Oil Pressure Diagnosis and Testing >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Switch off the engine.
  2. Remove the EN-232  adapter.
  3. Remove the EN-498-B  gauge.
  4. Install new closure bolt in the cylinder head.
  5. Tighten the closure bolt to 15 N.m (11 lb ft).
    CAUTION: Refer to Fastener Caution .
  6. If necessary, install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (1.8L LUW and LWE) .
  7. Check the engine oil level.
scientia non olet · About LEMON Manuals