LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Diagnostic Information and Procedures >> Cylinder Leakage Test >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the pressure loss tester.
  2. Remove the connection piece from the spark plug thread.
  3. Put the vehicle in neutral.
  4. Insert the oil dipstick.
  5. Install the coolant expansion tank closure cap.
  6. Install the spark plugs. Refer to Spark Plug Replacement .
  7. Install the engine wiring harness to the intake manifold.
  8. Install the timing belt upper front cover. Refer to Timing Belt Upper Front Cover Installation .
  9. Raise and support the vehicle.
  10. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement
  11. Lower the vehicle.
  12. Close the hood.
scientia non olet · About LEMON Manuals