LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LUW And LWE)) >> Diagnostic Information and Procedures >> Coolant in Engine Oil

Coolant in Engine Oil

WARNING: This page is about a different variant/trim than selected.
Cause Correction
DEFINITION: Foamy or discolored oil or an engine oil overfill condition may indicate coolant entering the engine crankcase. Low coolant levels, an inoperative cooling fan or a faulty thermostat may lead to an overtemperature condition which may cause engine component damage. Contaminated engine oil and oil filter should be changed.
  1. Inspect the oil for excessive foaming or an overfill condition. Oil diluted by coolant may not properly lubricate the crankshaft bearings and may lead to component damage. Refer to Lower Engine Noise, Regardless of Engine Speed .
  2. Inspect by performing a cylinder leak-down test. During this test, excessive air bubbles within the cooling system may indicate a faulty gasket or damaged component.
  3. Inspect by performing a cylinder compression test. Two cylinders side-by-side on the engine block with low compression may indicate a failed cylinder head gasket. Refer to Engine Compression Test .
Faulty cylinder head gasket Replace the head gasket and components as required. Refer to Cylinder Head Replacement .
Warped cylinder head Replace the cylinder head and gasket. Refer to Cylinder Head Replacement .
Cracked cylinder head Replace the cylinder head and gasket. Cylinder Head Replacement 
Cracked cylinder liner Replace the components as required.
Cylinder head or block porosity Replace the components as required.
scientia non olet · About LEMON Manuals