Separating Parts
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Disassembly of the piston, press fit design piston pin and connecting rod may create scoring or damage to the piston pin and piston pin bore. If the piston, pin and connecting rod have been disassembled, replace the components as an assembly.
- Many internal engine components will develop specific wear patterns on their friction surfaces.
- When disassembling the engine, internal components MUST be separated, marked or organized in a way to ensure installation to their original location and position.
Separate, mark or organize the following components:
- Piston and the piston pin
- Piston to the specific cylinder bore
- Piston rings to the piston
- Connecting rod to the crankshaft journal
- Connecting rod to the bearing cap-A paint stick or etching/engraving type tool are recommended. Stamping the connecting rod or cap near the bearing bore may affect component geometry.
- Crankshaft main and connecting rod bearings
- Camshaft and valve tappets
- Valve to the valve guide
- Valve spring and shim to the cylinder head location
- Engine block main bearing cap location and direction
- Oil pump drive and driven gears