Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install NEW transmission control lever (2).

Fig 1: Transmission Control Lever And Bolts
Courtesy of GENERAL MOTORS COMPANY
Install 4 transmission control lever bolts (1) and tighten to 8 N.m (71 lb in).
CAUTION: Refer to Fastener Caution .
Slide shift lever and selector lever cable into shift lever and selector lever cable adjust locks (2).

Fig 2: Selector Lever Cable, Adjust Locks And Transmission Control Lever Housing
Courtesy of GENERAL MOTORS COMPANY

NOTE: Do not lock yet.
Clip shift lever and selector lever cable (3) into transmission control lever housing (1).
Adjust shift lever and selector lever cable. Refer to Manual Transmission Shift Lever and Selector Lever Cable Adjustment .