LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Shift Control Housing Replacement (1.8L LUW and LWE) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Shift Control Housing Seal (1) »Install a NEW O-ring seal.
    Fig 1: Identifying Shift Control Housing Seal
    GM4248366Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Prior to starting the installation process, confirm that the old shift control housing seal is removed.
    • A NEW seal should be provided with the replacement shift control housings. If the old shift control housing will be re-used, a NEW seal is still required.
    • Make sure that the NEW vent cap is installed by the NEW shift control housing.
  2. Verify that the shift forks (1) align.
    Fig 2: Identifying Shift Forks
    GM4199184Courtesy of GENERAL MOTORS COMPANY
  3. Shift Control Housing (1)»Install
    Fig 3: Identifying Shift Control Housing
    GM4248410Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • The lower shift control housing shaft is difficult to insert into the bearing.
    • To facilitate the installation block the shift control housing.
  4. Shift Control Housing Bolt (1) @ Shift Control Housing (2) » Install and tighten [2x] (20 N.m (15 lb ft)
    Fig 4: Identifying Shift Control Housing And Bolt
    GM4248409Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Fastener Caution
    CAUTION: Ensure that the shift control housing flange is fully seated against the transmission case. If the flange does not fully seat, then the housing shaft is not properly seated in the case bushing and must be realigned. The housing shaft must be fully seated in the case bushing. Failure to follow this caution will result in transmission failure.
  5. Move the blocking device (1) along the arrow in order to unblock the shift control housing.
    Fig 5: Identifying Blocking Device
    GM3966423Courtesy of GENERAL MOTORS COMPANY
  6. Backup Lamp Switch Replacement »Install.
  7. Selector Lever and Shift Lever Cable @ Shift Control Housing»Install - Refer to Manual Transmission Shift Lever and Selector Lever Cable Replacement 
  8. Manual Transmission Shift Lever and Selector Lever Cable Adjustment »Adjust
    NOTE: Always perform the selector lever cable adjustment procedure, even if the cables appear to fit properly.
  9. Verify correct operation of the transmission control assembly.
  10. Battery Tray Replacement »Install
scientia non olet · About LEMON Manuals