LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Manual Transmission - M32) >> Repair Instructions - On Vehicle >> Selector and Shift Lever Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install shift lever and selector lever cable bracket (2).
    Fig 1: Selector Lever Cable Bracket And Bolts
    GM2191517Courtesy of GENERAL MOTORS COMPANY
  2. Install 2 shift lever and selector lever cable bracket bolts (1) and tighten to 20 N.m (15 lb ft).
    CAUTION: Refer to Fastener Caution .
  3. Install shift lever and selector lever cable (2) to shift lever and selector lever cable bracket (1).
    Fig 2: Selector Lever Cable, Bracket And Transmission Control Housing
    GM2191413Courtesy of GENERAL MOTORS COMPANY
  4. Install shift lever and selector lever cable to transmission control housing (3).
  5. Install battery tray. Refer to Battery Tray Replacement .
scientia non olet · About LEMON Manuals