Input and Main Shaft Bearing Replacement: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools
- CH-500-5 Arbor from CH-500-A Remover/Installer Kit
- DT-113-2-A Holder
- DT-307-B Remover Plate
- DT-523-1 Handle from DT-523 Remover/Installer Kit
- DT-6115 Holder Clutch Housing
- DT-6339 Installer
- DT-46759 Sleeve
- DT-60000 Tool Kit
- DT-60000-85 Bearing Remover
- DT-60000-105 Bearing Installer
- DT-60000-125 Adapter Kit for DT-60000-120
- DT-60000-135 Adapter Kit for DT-60000-130
- DT-60000-180 Bearing Cup Lifter
- EN-235-5-1 Arbor from EN-235-D Assembly Tool Kit
- EN-45059 Angle Meter
- GE-396 Ring Pliers
Equivalent regional tools: Special Tools
NOTE:
- Ambient temperature must be between 15-25°C (59-77°F).
- The components of the transmission shafts must not be dropped or bumped! Dropped or bumped parts must not be installed!