LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Manual Transmission - M32) >> Diagnostic Information and Procedures >> DTC P0806-P0808: Clutch Pedal Position (CPP) Sensor >> Component Testing >> Static Test

Static Test

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector of the B25B Clutch Pedal Position Sensor.
  2. Measure the resistance between the signal terminal B and the low reference terminal A at the B25B Clutch Pedal Position Sensor. Depress the clutch pedal through the entire range. The resistance should vary from low to high and vice versa without any spikes or dropouts.
    • If the resistance is erratic with spikes or dropouts 

      Replace the B25B Clutch Pedal Position Sensor.

    • If the resistance is not erratic without spikes or dropouts 
  3. All OK.
scientia non olet · About LEMON Manuals