Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P0502

DTC P0503 is not set.
Accelerator pedal position is more than 8%.
Engine is running.
System voltage is 9-32 V.
Engine speed is 1, 500-6, 500 RPM.
Engine torque is greater than 54 N.m (40 lb ft).
DTC runs continuously when the above conditions are met.

P0503

System voltage is 9-32 V.
Engine speed is 200-7, 500 RPM.
Transmission output speed is at least 292 RPM for 5 s.
Transmission output shaft speed change is less than 124 RPM for 5 s.
DTC runs continuously when the above conditions are met.