Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON.
Verify DTC P0651 is not set.
- If DTC P0651 is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If DTC P0651 is not set
Raise and support the drive wheels in a horizontal position.
CAUTION: Support the lower control arms in the normal horizontal position in order to avoid damage to the drive axles. Do not operate the vehicle in gear with the wheels hanging down at full travel.
Start and idle the engine.
Place the transmission in second gear and release the clutch pedal.
Verify the scan tool Vehicle Speed Sensor parameter increases as the drive wheel speed increases.
- If the Vehicle Speed Sensor parameter does not increase
  Refer to Circuit/System Testing .
- If the Vehicle Speed Sensor parameter does increase
Operate the vehicle within the conditions for running the DTC to verify the DTC does not set. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.