Location of the Shafts
WARNING: This page is about a different variant/trim than selected.
The following cross-sectional diagram shows the location of the respective shafts in the M32-6 transmission, as per the 3-shaft principle.
| Callout | Component Name |
|---|---|
| 1 | Upper Main Shaft |
| 2 | Input Shaft |
| 3 | Lower Main Shaft |
| 4 | Differential Gear |
In this transmission angular cone bearings are used for all shafts. These bearings require a certain amount of play and pretension. The required amount of bearing play and pretension is achieved at the production stage by using shims under the angular cone bearing in the transmission housing.