LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - Repair Instructions) >> Repair Instructions >> Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the turbocharger wastegate actuator vacuum control solenoid valve splash shield. Refer to Turbocharger Wastegate Actuator Vacuum Control Solenoid Valve Splash Shield Replacement .
    WARNING: In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.
  3. Loosen the exhaust gas recirculation valve temperature sensor (2), use a suitable tool (1), e.g. a crow foot.
    Fig 1: Exhaust Gas Recirculation Valve Temperature Sensor
    GM3216280Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the exhaust gas recirculation valve temperature sensor wiring harness plug (2).
    Fig 2: Exhaust Gas Recirculation Valve Temperature Sensor Wiring Harness Plug
    GM3216279Courtesy of GENERAL MOTORS COMPANY
  5. Remove the exhaust gas recirculation valve temperature sensor wiring harness plug (2) out of the retainer (3).
  6. Remove the exhaust gas recirculation valve temperature sensor (1).
scientia non olet · About LEMON Manuals