Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the air cleaner upper housing. Refer to Air Cleaner Upper Housing Replacement .
- Remove the air cleaner element. Refer to Air Cleaner Element Replacement .
- Remove the NOX sensor - position 1 module from the air cleaner lower housing. Refer to Nitrogen Oxides Sensor Replacement - Position 1 .
- Unclip the water drain hose (3) from the air cleaner lower housing (1) if equipped.
- Remove the air cleaner lower housing (1) from the air cleaner brackets.
- Remove the air cleaner bracket insulators (2) from the air cleaner lower housing (1).
- Remove the air cleaner insulator (4) from the air cleaner lower housing (1).