LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - DTC P2122 To DTC P2689 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Water-in-Fuel Lamp Diagnosis >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
NOTE: You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.
  1. Ignition OFF and all vehicle systems OFF. Disconnect the harness connector at the B116 Water in Fuel Sensor. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 10Ω between the Ground circuit terminal 4 and ground.
    • If 10Ω or greater 
    1. Ignition OFF, disconnect Ground G402.

      Refer to Ground Views .

    2. Test for less than 2Ω in the ground circuit end to end.
      • If 2Ω or greater, repair the open or high resistance in the circuit.
      • If less than 2Ω, repair the open/high resistance in the ground connection.
    • If less than 10Ω 
  3. Reconnect the harness connector at the B116 Water in Fuel Sensor.
  4. Ignition ON.
  5. Using the scan tool, observe the Water in Fuel parameter. The parameter should display NO.
    • If NO is not displayed 
    1. Ignition OFF.
    2. Test for infinite resistance between the B116 Water in Fuel Sensor Signal circuit terminal 3 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K20 Engine Control Module.
    • If NO is displayed 
  6. Install a 3 A fused jumper wire between the Signal circuit terminal 3 and the Ground circuit terminal 4. The Water In Fuel Sensor parameter should display YES.
    • If the 3 A fuse opens and the Water In Fuel Sensor parameter does not display YES 

      Test the Signal circuit for a short to voltage. If the circuit tests normal replace the K20 Engine Control Module.

    • If the 3 A fuse does not open and the Water In Fuel Sensor parameter does not display YES 

      Test the Signal circuit for an open. If the circuit tests normal replace the K20 Engine Control Module.

    • If the 3 A fuse does not open and the Water In Fuel Sensor parameter displays YES 
  7. Replace the B116 Water in Fuel Sensor.
scientia non olet · About LEMON Manuals