Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF.
- Disconnect the KR23A Fuel Pump Relay.
- Test for 70-110 Ω between terminals 85 and 86.
- If not between 70-110 Ω
Replace the KR23A Fuel Pump Relay.
- If between 70-110 Ω
- If not between 70-110 Ω
- Test for infinite resistance between the following terminals:
- 30 and 86
- 30 and 87
- 30 and 85
- 85 and 87
- If less than infinite resistance
Replace the KR23A Fuel Pump Relay.
- If infinite resistance
- Install a 20 A fused jumper wire between relay terminal 85 and 12 V.
- Install a jumper wire between relay terminal 86 and ground.
- Test for less than 2 Ω between terminals 30 and 87.
- If 2 Ω or greater
Replace the KR23A Fuel Pump Relay.
- If 2 Ω or less
- If 2 Ω or greater
- All OK