Repair Instructions
WARNING: This page is about a different variant/trim than selected.
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
- Fuel Injection Pump Replacement for the G18 High Pressure Fuel Pump replacement.
- Fuel Injector Replacement
- Perform the Fuel Injector Flow Rate Programming procedure after replacement of a fuel injector.
- Perform the scan tool Diesel Particulate Filter (DPF) Regeneration Enable , procedure if the scan tool DPF Soot Mass is less than 32 g. If the scan tool DPF Soot Mass is 32 g or greater, perform the Diesel Particulate Filter (DPF) Service Regeneration procedure.