Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify the fuel heater relay clicks when commanding the Fuel Heater Relay ON and OFF with a scan tool.
- If the fuel heater relay does not click
Refer to Circuit/System Testing.
- If the fuel heater relay clicks
- If the fuel heater relay does not click
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC is not set
- If the DTC sets
- All OK.