Exhaust Gas Recirculation Cooler Bypass Solenoid Valve Static Test
WARNING: This page is about a different variant/trim than selected.
- Ignition Off, disconnect the harness connector at the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve.
- Test for 25-40 Ω between the ignition circuit terminal 1 and the control terminal 2.
- If not between 25-40 Ω
Replace the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve.
- If between 25-40 Ω
- If not between 25-40 Ω
- All OK