Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify DTC P0641 is not set
- If the DTC is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If the DTC is not set
- If the DTC is set
- Engine running.
- Verify the scan tool Turbocharger Vane Position Sensor and the Desired Turbocharger Vane Position parameters change and remain within 2 % while slowly increasing the engine speed to 2, 500 RPM, then returning the engine speed to idle.
- If the parameters do not change or do not remain within 2%.
Refer to Circuit/System testing
- If the parameters change and remain within 2%.
- If the parameters do not change or do not remain within 2%.
- All OK