Diagnostic Fault Information
WARNING: This page is about a different variant/trim than selected.
| ECM Circuits | Short to Ground | Open | Short to Voltage | Signal Performance |
|---|---|---|---|---|
| Engine Controls Ignition Battery Voltage - Switch | ** | ** | - | - |
| Engine Controls Ignition Battery Voltage - Coil | ** | ** | - | - |
| ECM Ignition Voltage | ** | ** | P2510* | - |
| Engine Controls Ignition Relay Control | P2510* | ** | ** | - |
| * DTC will set only after the ECM powers down ** These circuit faults will cause a loss of communication with the scan tool and a no crank, no start condition. |
||||