LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - DTC P2122 To DTC P2689 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P24B3-P24B7: Particulate Matter Sensor Heater >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition On.
  2. Verify DTC P0101, P102, P0103 P0107, P0108, P0401, P0402, P0405, P0406, P0545, P0546, P2080, P2084, P242B, P242C, P242D, P1472 or U02A3 is not set.
    • If none of the DTCs are set 
  3. Ignition Off for greater than 120 min.
  4. Engine running, verify the scan tool Start-Up Particulate Matter Sensor Temperature is between -30 to +200°C (-22 to +392°F).
    • If not between -30 to +200°C (-22 to +392°F) 

      Replace the B136 Exhaust Particulate Matter Sensor

    • If between -30 to +200°C (-22 to +392°F) 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTCs does not set 
  7. All OK.
scientia non olet · About LEMON Manuals