Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition On.
- Verify DTC UXXX is not set.
- If a DTC is set
- If a DTC is not set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Replace the B136 Exhaust Particulate Matter Sensor
- If the DTCs does not set
- If the DTC sets
- All OK.