Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, verify a click is heard or felt from the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve when commanding the EGR Cooler Bypass Valve ON and OFF with a scan tool.NOTE: It may be necessary to clear the DTCs to enable scan tool output control function.
- If a click is not heard or felt
Refer to Circuit/System Testing
- If a click is heard or felt
- If a click is not heard or felt
- Operate the vehicle within the Conditions for Running the DTCs. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify a DTC does not set.
- If a DTC sets
Refer to Circuit/System Testing
- If a DTC does not set
- If a DTC sets
- All OK.