Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Verify DTC P2228 or P2229 is not set.
- If a DTC is set
Refer to Circuit/System testing
- If no DTC is set
- If a DTC is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing
- If the DTC does not set
- If the DTC sets
- All OK.