Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF.
- Disconnect the harness connector at the appropriate Q17 Fuel Injector.
- Test for 150K-210K ohms between terminal 1 and terminal 2 of the Q17 Fuel Injector.
- If not within 150K to 210K ohms
Replace the appropriate Q17 Fuel Injector.
- If within 150K to 210K ohms
- If not within 150K to 210K ohms
- Test for infinite resistance between each terminal and the Q17 Fuel Injector housing/case.
- If not infinite resistance
Replace the Q17 Fuel Injector.
- If infinite resistance
- If not infinite resistance
- All OK.