Leak Test
WARNING: This page is about a different variant/trim than selected.
- Verify air leaks do not exist by listening for excessive hissing sounds and using a pump spray bottle to apply a soapy water solution, while observing for excessive soapy bubbles at the locations listed below:
- All air induction system hose clamps.
- Air cleaner outlet duct.
- Charge air cooler inlet and outlet hoses and ducts.
- Charge air cooler.
- Intake manifold gaskets and seals.
- If an air leaks exists
Repair or replace the affected gasket, seal, clamp or component as necessary and repeat step 1.
- If no air leaks exist
- All OK