Poor Fuel Fill Quality

WARNING: This page is about a different variant/trim than selected.

Condition	Causes
DEFINITION: During the fueling process a continual, occasional or no fuel nozzle shut-off condition has occurred.
Difficult to fill	Fuel fill limiter vent valve stuck closed Evaporative emission (EVAP) canister restricted High fuel temperature Fuel filler hose is kinked Faulty dispensing nozzle
Over fill	Fill limiter vent valve stuck open or leaking Fuel inlet check valve stuck open
Premature shut-off of the fuel dispensing nozzle occurs immediately after engaging dispensing nozzle, tank empty	Restricted vapor lines or fuel fill pipe High fuel temperature Inlet check valve at tank stuck closed, fill pipe full of fuel Fuel tank full, gauge not accurate
Premature shut-off of the fuel dispensing nozzle, more than 1/8 of tank capacity dispensed	Kinked, pinched or plugged lines in fuel tank vent system EVAP canister restricted Fuel limiting vent valve stuck closed or obstruction at top of fuel tank
Fuel spitback	Restricted EVAP canister High fuel temperature