Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
NOTE:
- DTC P2544 is an informational DTC.
- Diagnose all other engine control module DTCs prior to DTC P2544.
- Verify that no other DTCs are set except for DTC P2544.
- If any other DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If only DTC P2544 is set
- If any other DTCs are set
- Replace the K71 Transmission Control Module.
- Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
- Verify the DTC does not set.
- If DTC sets
Replace the K20 Engine Control Module.
- If DTC does not set
- If DTC sets
- All OK.