Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.

Engine idling, verify the manifold absolute pressure (MAP) sensor parameter is between 20-48 kPa.
- If not within the specified range .
  Refer to DTC P0106 .
- If within the specified range, verify that none of the conditions listed below exist:
- Modified, damaged, leaking or restricted air induction system components.
- Improper operation of the crankcase ventilation system. Refer to Crankcase Ventilation System Inspection/Diagnosis .
- Split, kinked or improperly connected vacuum hoses.
- Restricted, damaged, leaking or modified exhaust system from the catalytic converter forward. Refer to Symptoms - Engine Exhaust .
- Improperly operating fuel injectors. Refer to Fuel Injector Diagnosis .
- Contaminated fuel. Refer to Alcohol/Contaminants-in-Fuel Diagnosis .
- Excessive fuel in the crankcase due to leaking injectors. Change engine oil as necessary.
- Improper ignition system operation. Refer to Electronic Ignition System Diagnosis .
- If a condition is found
  Repair as necessary.
- If no condition is found
Test the engine for any mechanical conditions such as sticking valves, lifters, etc., which could alter the flow into the combustion chamber. Refer to Symptoms - Engine Mechanical .