Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON
- Verify that DTC P2077 or P2078 is not set.
- If any of the DTCs are set
Refer to Circuit/System Testing
- If none of the DTCs are set.
- If any of the DTCs are set
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify a DTC does not set.
- If a DTC sets
Refer to Circuit/System Testing
- If a DTC does not set
- If a DTC sets
- All OK