Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0119, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0222, P0223, P0300, P0301, P0302, P0303, P0304, P0335, P0336, P0351, P0352, P0353, P0354, P0502, P0503, P0506, P0507, P0697, P06A3, P0722, P0723, P0806, P0807, P0808, P182E, P1915, P2122, P2123, P2127, P2128, P2135 and P2138 are not set.
- The catalyst temperature is less than 300°C (572°F).
- The engine coolant temperature (ECT) sensor is greater than -10°C (14°F).
- The vehicle speed is less than 2 km/h (1 MPH).
- The ECM will exit the diagnostic if the calculated three way catalyst temperature is greater than 700°C (1292°F) and the engine run time is greater than 30 s.
- The ECM will exit the diagnostic if the ECT is greater than 40°C (104°F) or the engine run time is greater than 80 s.
- This DTC runs within the first 10 s of start up. This diagnostic runs once per trip when a cold start has been determined.