Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0685
The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 2 s.
P0686
The ECM detects a short to ground on the control circuit for greater than 2 s.
P0687
The ECM detects a short to voltage on the control circuit for greater than 2 s.
P0689
The ECM detects the engine controls ignition relay feedback circuit is less than 5 V for greater than 5 s.
P0690
The ECM detects the engine controls ignition relay feedback circuit is greater than 2 V for greater than 4 s.
P1682
The ECM detects that the voltage level difference is greater than 3 V between the 2 ignition voltage circuits for greater than 1 s.