Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0119, P0121, P0122, P0123, P0128, P0171, P0172, P0201, P0202, P0203, P0204, P0222, P0223, P0300, P0351, P0352, P0353, P0354, P0461, P0462, P0463, P0496, P0502, P0503, P0606, P0697, P06A3, P0806, P0807, P0808, P16F3, P2101, P2122, P2123, P2127, P2128, P2135, P2138 or P2771 are not set.
The barometric pressure (BARO) is greater than 70 kPa.
The engine runtime is greater than 60 s.
The engine is idling for greater than 10 s.
The torque converter clutch (TCC) is not changing states.
The transmission is not changing gears.
The intake air temperature (IAT) is greater than -20°C (-4°F).
The engine coolant temperature (ECT) is between 60-120°C (140-248°F).
The ignition voltage is between 11-32 V.
The vehicle speed is less than 3.2 km/h (2 mph).
The commanded engine speed is steady within 25 RPM.
The DTCs run continuously when the above conditions are met for greater than 10 s.