LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls And Fuel - 1.8L (LUW, LWE) - DTC P0443 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0496: Evaporative Emission (EVAP) System Flow >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

This DTC tests for undesired intake manifold vacuum flow to the evaporative emission (EVAP) system. The engine control module (ECM) seals the EVAP system by commanding the EVAP purge solenoid valve OFF and the vent solenoid valve ON. The ECM monitors the fuel tank pressure (FTP) sensor to determine if a vacuum is being drawn on the EVAP system. If vacuum in the EVAP system is more than a predetermined value within a predetermined time, this DTC sets.

The table listed below illustrates the relationship between the ON and OFF states and the Open or Closed states of the EVAP purge and vent solenoid valves.

ECM Command EVAP Purge Solenoid Valve EVAP Vent Solenoid Valve
ON Open Closed
OFF Closed Open
scientia non olet · About LEMON Manuals