Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P20B9, P20BD or P20C1
The ECM receives a GPCM serial data message indicating the heater control circuit is open for greater than 3 s.
P20BB, P20BF or P20C3
The ECM receives a GPCM serial data message indicating the heater control circuit is shorted to ground or overloaded for greater than 1 s.
P20BC, P20C0 or P20C4
The ECM receives a GPCM serial data message indicating the heater control circuit is shorted to a voltage for greater than 2 s.