Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P205B
- Ignition is Off for 8 hours.
- The ECM monitors the ECT, Exhaust Gas Temperature (EGT) 2 and EGT 3 for the coldest and warmest of the three sensors. The difference between the coldest and warmest should be less than 14°C (25°F).
- Engine speed is greater than 600 RPM for 10 minutes since cold start.
- Battery voltage is greater than 11 V for at least 3 s.
- The DTCs run once per drive cycle when the above conditions are met for greater than 20 s.
P205C and P205D
- Engine speed is greater than 600 RPM for less than 10 s.
- Battery voltage is greater than 11 V for at least 3 s.
- The DTCs run continuously when the above conditions are met.