Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition On.
- Verify DTC UXXXX is not set.
- If a DTC is set
- If no DTC is set
- Observe the scan tool Reductant Temperature parameter. The reading should be warmer than -55°C (-67°F) and colder than 160°C (320°F).
- If not within the specified range
Replace the reductant temperature sensor.
- If within the specified range
- If not within the specified range
- Observe the scan tool Fuel Temperature Sensor parameter. The reading should be warmer than -55°C (-67°F) and colder 160°C (320°F).
- If not within the specified range
Refer to DTC P0182 or P0183 .
- If within the specified range
- If not within the specified range
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify a DTC does not set.
- If any DTC sets
Refer to Circuit/System Testing.
- If no DTC sets
- If any DTC sets
- All OK.