Repair Verification
WARNING: This page is about a different variant/trim than selected.
- Install any components or connectors that have been removed or replaced during diagnosis.
- Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
- Clear the DTCs.
- Ignition Off, all vehicle systems Off, this may take up to 2 minutes.
- Engine idling for 30 s.
- Ignition Off, all vehicle systems Off, this may take up to 2 minutes.
- Ignition On.
- Command the Reductant System Data Reset On with a scan tool.
- Ignition Off, all vehicle systems Off, this may take up to 2 minutes.
- Ignition On, verify the Service Emission System message or reductant lamp turns Off, if illuminated
- If the Service Emission System message or reductant lamp does not turn Off
A condition with the system still exists
- If the Service Emission System message or reductant lamp turns Off
- If the Service Emission System message or reductant lamp does not turn Off
- All OK.